ULTRASONIC SOLIDS MONITORING AND CONTROL SYSTEM

MSM 400 ULTRASONIC SOLIDS MONITORING AND CONTROL SYSTEM

Mobrey

Controller

To run at your full potential and maximize process control, you need reliable level instrumentation throughout your facility. The Mobrey MSM400 system continuously monitors the suspended solids or sludge density contained in, or flowing from, a clarifier or settlement tank during de-sludging. Many years of practical experience have shown that measurement of ultrasonic attenuation in a slurry is directly proportional to the percentage of suspended solids.The MSM400 system uses this principle to produce a digital display of the suspended solids measurement.

SPECIFICATION

Housing Material

ABS enclosure with clear polycarbonate lid.

Operating Pressure

Up to 1523 psi (105 bar)

Power Supply

AC mains and DC terminal connections on control unit for external supply.Auto-selection of AC or DC supply,allowing back-up if one power supply fails.
AC supply: 115 or 230 Vac ±15% (switch selectable)
DC supply: 15 to 30 Vdc, 24 Vdc nominal

Output Signal
4-20 mA (default) or 0-20 mA, software selectable.
Two off SPDT (single-pole-double-throw) relays.

Display/Interface

Integral 32 x 122 pixels LCD with backlight, providing up to four lines of characters on control unit.

Ambiente Temperature

-22 to 131 °F (-30 to 55 °C) for control unit.

Operating Temperature

See Product Data Sheet for all sensor operating temperature ranges.